Instructions [exclusive] | Caraflo V200 Shower

[Main Supply Off] ➔ [Remove Bottom Hose] ➔ [Insert Drain-Down Key] ➔ [Disconnect Quick-Tails]

If installing inside a Plast-Tech, Bridgewood, or Lamplas shower pod, ensure the mounting holes are spaced exactly 45mm apart.

| Parameter | Specification | | :--- | :--- | | | 10 bar | | Flow Pressure (Hot & Cold) | 0.5 - 5 bar | | Max Mixed Water Temperature | 46°C | | Recommended Max Shower Temp | 41°C | | Hot Supply Temperature | 55 - 65°C | | Cold Supply Temperature | ≤ 25°C | caraflo v200 shower instructions

Insert the drain-down key into the designated drain port located on the underside or base of the valve body.

Do not overtighten; a secure hand-tight turn followed by a quarter-turn with a wrench is typically sufficient. Step 4: Connecting the Shower Kit [Main Supply Off] ➔ [Remove Bottom Hose] ➔

The V200 requires a standard two-hole mount with a consistent center-to-center measurement (usually around 100mm to 110mm, but verify with your unit).

Before beginning installation, verify your existing layout matches the structural dimensions of the V200. This unit features full for optimal anti-scald protection. Specification Pipe Centres Spacing 45mm (Hole centres) Orientation Horizontal or Vertical installation Cartridge Style Screw-in Plastic Nylon with Vernet 0847 copper thermostat Tail Dimensions 45mm length x 20mm outlet diameter Physical Dimensions Height: 165mm (vertical) Compatible Pods Plast-Tech, Bridgewood, and Lamplas shower cubicles ⚙️ Step-by-Step Installation Instructions Step 4: Connecting the Shower Kit The V200

Open all taps (including the shower) to the "mid" position between hot and cold.

Rinse with clean water, grease the black O-rings with silicone grease, and reassemble. Winterization (Crucial for Caravans)

Check that your water lines match standard .

: Shut off the main external park stopcock. Open all caravan taps to dump line pressure.