Sn51dp Datasheet (99% Instant)

Would you like a sample PCB layout or snubber calculation for this part?

Input for PWM or analog dimming signals to control brightness.

Understanding the pinout is essential for troubleshooting. The SN51DP utilizes a standard 10-pin configuration (SSOP-10). Based on circuit analysis and practical voltage measurements from working TVs, the following pin functions have been identified:

I can guide you through specific component checks or help you select a compatible pin-to-pin replacement IC. Share public link sn51dp datasheet

A: It is a dedicated LED backlight driver IC, primarily found in LCD televisions to convert a main power rail (e.g., 12V or 24V) into the high voltage needed to light the screen.

| Parameter | Symbol | Typical | Unit | Description | | :--- | :--- | :--- | :--- | :--- | | Rise Time | tr | 20 | ns | Time for output to rise from 10% to 90% of VDD | | Fall Time | tf | 20 | ns | Time for output to fall from 90% to 10% of VDD | | Propagation Delay | tpd | 25 | ns | Delay from input signal change to output response |

The driver section is designed to transmit data over long distances. It has a high-impedance output when disabled, allowing multiple drivers to be connected to a single bus. Would you like a sample PCB layout or

Current Set pin. By adjusting the resistor value connected to this pin, technicians can dictate the maximum current supplied to the backlight LEDs, helping prolong panel lifespan.

: Feedback loop. Tracks the output voltage to keep the circuit safely inside its regulated envelope.

: Dimming control input. Processes pulse width modulation signals to adjust display luminance. | Parameter | Symbol | Typical | Unit

The is a Zero-Cross Phototriac Coupler (also called a Phototriac or SSR driver). It is designed to interface low-voltage control logic (e.g., microcontrollers, 5V logic) with high-voltage AC loads (e.g., motors, solenoids, heaters, lamps) by driving an external power triac or directly controlling small AC loads.

| Pin Number | Function | Expected Voltage (Operational) | | :--- | :--- | :--- | | 1 | VCC (Power Supply) | 12V | | 2 | N/C or Ground | 0V | | 4 | | N/A | | 5 | Feedback/Enable | 2.5V | | 9 | Over-Voltage Protection (OVP) | 1.55V | | 10 | Dimming/PWM Input | 3.1V |