Includes built-in overload protection and flame-retardant PC/ABS engineering plastics. ⚙️ Step-by-Step Setup & Wi-Fi Pairing
Opening the outer casing or altering the internal wiring voids the warranty and poses severe electrical hazards. 6. Troubleshooting Guide Issue Identified Probable Root Cause Corrective Action Steps Power strip loses Wi-Fi connection frequently. Weak local wireless signal or 5GHz network interference.
Disconnect all USB devices. Wait 60 seconds for the internal thermal fuse to reset, then attempt to charge a single standard smartphone.
Unlike traditional power strips that turn all connected devices on or off at once, the MTTL-W01 features . This flexibility allows you to keep your modem and router powered on while turning off your desk lamp and speakers, or power down a single computer monitor while leaving the CPU running.
I can provide the exact steps or wiring configurations to match your setup. Share public link mttl-w01 manual
Experiencing connectivity or performance issues? Most problems with smart power strips are related to router configurations or distance.
2.4 GHz Wi-Fi required (5 GHz is not supported). Voltage: 220V, 60Hz. Total Max Load: 3500 Watts / 16A.
| | Solution | |-----------------------------|--------------------------------------------| | No power | Check power adapter; verify outlet works. | | Connection failure | Restart device/app; reset network settings. | | Error Code “E01” | Refer to Appendix B for error code list. |
Use Huawei HiSuite on your computer to manage files, back up data, and restore your tablet. Wait 60 seconds for the internal thermal fuse
The is a high-performance, Wi-Fi-enabled smart power strip engineered by LG Uplus Corporation to deliver precise energy monitoring and appliance automation . Delivering up to 3.5KW of power capability (16A, 250V) , this device integrates four individually controlled AC outlets and dual USB charging ports.
If your tablet is freezing or acting slowly, consult the following steps: 4.1 Restart or Force Shutdown
Before doing anything else, find a convenient location for your power strip.
Not near your phone? No problem. The MTTL-W01 features a physical master power button. Pressing this button will manually turn all 4 outlets and the USB ports on or off simultaneously. 🛡️ Safety and Overload Protection Indoor Use Only For firmware updates
: If the overload protection triggers, disconnect all devices, reduce the total load, and reset the power strip. Indoor Use Only
For firmware updates, visit [URL].
Bring the sensor within 3 feet of the MTTL-W01 during the initial pairing process. You can move it to its final location afterward.
Press and hold the primary control button (or Outlet 1 button) for approximately .
Rev. 1.0 - March 2024
