Redsail Cutting Plotter Software Installation !full! Here

Artcut is the most common software bundled with Redsail machines.

: Keep the USB cable unplugged from the computer.

: Keep the Redsail plotter turned off until the drivers are installed.

Open Device Manager (Win+X → M). Under “Ports (COM & LPT),” you should see “Redsail Virtual COM Port (COM3)” or similar. If you see a yellow exclamation, skip to the Troubleshooting section. redsail cutting plotter software installation

Windows blocks the installation because the driver is unsigned. Solution:

This procedure is verified for and works for SignMaster + Redsail driver pack.

Are you using or a CorelDRAW plugin , and did you manage to find the correct COM port in your Device Manager? Artcut is the most common software bundled with

How to Install Software for Your Redsail Cutting Plotter: A Step-by-Step Guide

Run the installer, which automatically detects your active CorelDRAW version directory.

(e.g., COM3 or COM4). You will need this for your cutting software. Step 2: Install and Configure Your Software Open Device Manager (Win+X → M)

: Run the driver installer from your included CD or download the USB 2.0-Serial (CH340) driver online. Connect the plotter to your PC and power it on; your computer should now recognize it as a "USB Serial Port" in the Device Manager.

: Many Redsail plotters allow you to adjust cutting force (force ranges up to 500g) and speed (up to 600mm/s) directly through the software in real-time. Direct CorelDraw Output

A: ArtCut is abandonware and is difficult to find legally online. It is highly recommended to download SignMaster or VinylMaster (trial versions are usually sufficient to test the cutter).