Motorola Cp140 Programming Software

: It supports opening two "code plugs" at once, allowing you to drag and drop settings between different radios.

Once you have acquired the Commercial Series CPS software and your hardware components, follow this procedure to configure your CP140 units. Step 1: Install Drivers and Software

In the left-hand tree menu, navigate to -> Zone 1 . Click on Channels to view the configuration grid. motorola cp140 programming software

Select CSQ (Carrier Squelch), TPL (Tone Private Line / CTCSS), or DPL (Digital Private Line / DCS) to filter out unwanted chatter.

: Install the CPS on a PC with administrator rights and restart the computer to finalize registry changes. : It supports opening two "code plugs" at

Disclaimer: This article is for educational purposes. Motorola, CP140, and Professional Series are trademarks of Motorola Solutions, Inc. The author does not host or distribute copyrighted software. Always comply with local radio licensing laws when programming transmit frequencies.

Once all channels are configured, click the button on the toolbar (or press Ctrl + W ). A warning box will ask you to confirm. Click OK . Click on Channels to view the configuration grid

Plug the 2.5mm programming cable into the side accessory port of the radio. Plug the USB end into your PC. Turn the radio on and set the volume to a moderate level. Step 2: Configure the COM Port Open your PC’s .

If you have a legitimate installer (often setup.exe ), follow these steps: